升級器-軟件方法說明

1、 MST 106 Update Directions(1)升級說明(1)： 最先安裝USB驅動程序（CDM_Setup）如果安裝后下次使用時不用再安裝此驅動。運行ISP_Tool 4.4.0.4再將USB 升級工具聯(lián)上電腦和機器。如下圖：Firstly install USB drive software（CDM_Setup）and you dont need to install it again when next time you use it.Open ISP_Tool 4.4.0.4 and then connect the USB update tool between compu

2、ter and LCD TV as the illustration below: (1 OR 2)1 122步驟一：打開燒錄工具，點connect，此工具能自動識別Flash的型號和大小。Step one：Open the update program tool and click “connect”. This program can auto-check the model and the volume of the Flash. 步驟二：點擊Read,將待燒錄的文件導入 Step two：Click “Read” to lead in the software.步驟三：點擊Auto，將

3、“Blank, Program, Verify, Exit ISP”勾上，一般情況下只勾“Program, Exit ISP”也可燒錄，這樣速度會快一點。最后點擊“Run”，就OK了。Step three：Click “Auto” and tick off “Blank, Program, Verify, Exit ISP”. (Usually it can work and be quick when only ticking off “Program,Exit ISP”) Finally click “Run” is OK.注意：106和澳洲高清的程序都很大，燒錄時間比較長，大約3-4分鐘

4、； 另外，燒錄第一步時經常遇到連接不上，不要慌，只需將USB接口插拔幾次或者將此軟件關掉再點開幾次，一般來說就沒什么問題了。Warnings：For the volume of the 106 and Australia HD software are all big, it will take long time to update about 34 minutes. In addition, in the step one usually it will show connect is failed. Dont worry and you can just push and pull the USB several times or you can close the program tool and open it several times, then it should be ok. MST 106 Update Directions(2)升級說明(2)： USB Update1，準備一條USB線和一個U盤（如下圖） 1PCS USB CABLE ADN USB DISK（as the illustration below）2，將電視開機并將SOURCE 選為DTV3，將升級程序拷入U盤，文件名命名為usb，將USB CABL