Arginase-inhibitor-1 - Arginase 抑制劑 - 生命科學試劑 - MedChemExpress

1、Hotline: 400-820-3792Inhibitors Agonists Screening Librarieswww.MedChemEArginase inhibitor 1Cat. No.: HY-15775CAS No.: 1345808-25-4分式: CHBNO分量: 286.18作靶點: Arginase作通路: Immunology/Inflammation; Metabolic Enzyme/Protease儲存式: Powder -20C 3 years4C 2 yearsIn solvent -80C 6 months-20C 1 month溶解性數據體外實驗 DM

2、SO : 48 mg/mL (167.73 mM)H2O : 30 mg/mL (104.83 mM)* means soluble, but saturation unknown.Mass Solvent1 mg 5 mg 10 mg Concentration制備儲備液1 mM 3.4943 mL 17.4715 mL 34.9430 mL5 mM 0.6989 mL 3.4943 mL 6.9886 mL10 mM 0.3494 mL 1.7472 mL 3.4943 mL請根據產品在不同溶劑中的溶解度，選擇合適的溶劑配制儲備液，并請注意儲備液的保存式和期限。BIOLOGICAL ACT

3、IVITY物活性 Arginase inhibitor 1種有效的精氨酸酶 (arginases I 和 II)抑制劑，IC50 分別為 223 和 509 nM。IC50 & Target IC50: 223 nM (arginases I), 509 nM (arginases II) 1體外研究Arginase inhibitor 1inhibits human arginases I and II with IC50s of 22322.3 and 50985.1 nM, respectively,1/3 Master of Small Molecules 您邊的抑制劑師www.Med

4、ChemEand is active in a recombinant cellular assay overexpressing human arginase I (CHO cells). Arginaseinhibitor 1 is a novel second generation arginase inhibitor with significant activity in a rat model of myocardialischemia/reperfusion injury (MI/RI). Arginase inhibitor 1 is potent against hARG I

5、 in both in vitro enzyme andcellular assays. The IC50 for Arginase inhibitor 1 is 8 M in CHO Cells Over-Expressing hArgI 1.體內研究 A pharmacokinetic evaluation of Arginase inhibitor 1 is conducted after intravenous (i.v.) and oral (p.o.)dosing in male Sprague-Dawley rats (n=3 per dose route). Arginase

6、inhibitor 1 is formulated in 0.9% salineand administered intravenously at 10 mg/kg by bolus through a preimplanted cannula at a dosing volume of 1mL/kg, and orally at 10 mg/kg via gavage at a dosing volume of 2 mL/kg. Following i.v. dosing with 10 mg/kgin fasted animals, Arginase inhibitor 1has a te

7、rminal elimination half-life (t1/2) of 3.3 h with a volume ofdistribution and total body clearance of 1.86 L/kg and 7.89 mL/min/kg, respectively. The oral bioavailability ofArginase inhibitor 1 (10 mg/kg, p.o.) is 28% with a Cmax of 0.45 mg/L 1.PROTOCOLKinase Assay 1 Purified recombinant full length

8、 human arginase I protein and recombinant, fully active, truncated form ofhuman arginase II are used to develop 96-well plate human arginase I and arginase II assays. Inhibition ofarginase I and arginase II by program compounds is followed spectrophotometrically at 530 nm. Arginaseinhibitor 1 to be

9、tested is dissolved in DMSO at an initial concentration that is 50-fold greater than its finalconcentration in the cuvette. Ten microliters of the stock solution is diluted in 90 L of the assay buffer thatcomprised 0.1 M sodium phosphate buffer containing 130 mM NaCl, pH 7.4, to which is added ovalb

10、umin(OVA) at a concentration of 1 mg/mL. Solutions of arginase I and II are prepared in 100 mM sodiumphosphate buffer, pH 7.4, containing 1 mg/mL of OVA to give an arginase stock solution at a finalconcentration of 100 ng/mL. To each well of a 96-well microtiter plate is added 40 L of enzyme, 10 L o

11、f theArginase inhibitor 1 solution, and 10 L of enzyme substrate solution (L-arginine+Manganese sulfate). Forwells that are used as positive controls, only the enzyme and its substrate are added, while wells used asnegative controls contained only manganese sulfate. After incubating the microtiter p

12、late at 37C for 60 min,150 L of a urea reagent obtained by combining equal proportions (1:1) of reagents A and B is added to eachwell of the microtiter plate to stop the reaction. The urea reagent is made just before use by combiningReagent A (10 mM o-phthaldialdehyde and 0.4% polyoxyethylene lauryl

13、 ether (w/v) in 1.8 M sulfuric acid)with Reagent B (1.3 mM primaquine diphosphate, 0.4% polyoxyethylene lauryl ether (w/v), and 130 mM boricacid in 3.6 M sulfuric acid). After quenching the reaction mixture, the microtiter plate is allowed to stand for anadditional 10 min at room temperature in orde

14、r to allow color development. The inhibition of arginase iscomputed by measuring the optical density (OD) of the reaction mixture at 530 nm and normalizing the ODvalue to percent inhibition observed in the control. The normalized OD is then used to generate aconcentation-response curve by plotting t

15、he normalized OD values against logconcentration and usingregression analysis to compute the IC50 values 1.MCE has not independently confirmed the accuracy of these methods. They are for reference only.Animal Rats 1Administration 1 Single dose pharmacokinetics are evaluated in male Sprague-Dawley ra

16、ts by intravenous bolus (i.v.) and oral(p.o.) dosing. Three rats are evaluated per dose group. Arginase inhibitor 1 is freshly formulated in 0.9%saline prior to dosing, at 10 mg/mL for i.v. dosing at a dose volume of 1 mL/kg animal body weight, and at 52/3 Master of Small Molecules 您邊的抑制劑師www.MedChe

17、mEmg/mL for p.o. dosing at a dose volume of 2 mL/kg. Animals are fasted overnight prior to dosing, with watergiven ad libitum. Arginase inhibitor 1 is administered i.v. through a preimplanted cannula or orally by gavage.Food is reintroduced to animals 4 h following dosing. Blood samples are collecte

18、d through preimplantedcannulae (dual cannulated animals used for i.v. dosing; blood collection separate from dosing cannula) at0.25 mL per draw, followed by volume replacement with 0.9% saline. Samples are collected at predose 0.083(i.v. only), 0.25, 0.5, 1, 2, 4, 6, 8, and 24 h following dosing. Bl

19、ood samples are maintained on ice andcentrifuged at 10 000g to obtain plasma. Plasma is frozen at -20 C prior to analysis. Analysis is performedby LC/MS/MS using Agilent 1100 HPLC pumps with detection on a PESciex API 4000 Qtrap.Pharmacokinetic evaluation is performed using standard noncompartmental analyses in Phoenix WinNonlinsoftware.MCE has not independently confirmed the accuracy of these me