電氣專業外文翻譯---抗雷擊架空配電線路的可靠性

1、.外文資料翻譯Reliability of Lightning Resistant Overhead Distribution Lines Lighting continues to be the major cause of outages on overhead power distribution lines. Through laboratory testing and field observations and measurements, the properties of a lightning stroke and its effects on electrical distr

2、ibution system components are well-understood phenomena. This paper presents a compilation of 32 years of historical records for outage causes, duration, and locations for eight distribution feeders at the Oak Ridge National Laboratory (ORNL) .Distribution type lightning arresters are placed at dead

3、-end and angle structures at pole mounted wormer locations and at high points on the overhead line. Station class lightning arresters are used to protect underground cable runs, pad mounted switchgear and unit substation transformers. Resistance to earth of each pole ground is typically 15 ohms or l

4、ess. At higher elevations in the system, resistance to earth is substantially greater than 15 ohms, especially during the dry summer months. At these high points, ground rods were riven and bonded to the pole grounding systems in the 1960's in an attempt to decrease lightning outages. These atte

5、mpts were only partially successful in lowering the outage rate. From a surge protection standpoint the variety of pole structures used (in-line, corner, angle, dead end, etc.) and the variety of insulators and hardware used does not allow each 13.8 kV overhead line to be categorized with a uniform

6、impulse flashover rating (170 kV, etc.) or a numerical BIL voltage class (95 kV BIL; etc.). For simplicity purposes in the analysis, each overhead line was categorized with a nominal voltage construction class (15 kV, 34 kV, or 69 KV). Six of the eight overhead lines (feeders 1 through 6) were built

7、 with typical REA Standard horizontal wood cross arm construction utilizing single ANSI Class 55-5 porcelain pin insulators (nominal 15 kV insulation). The shield angle of the overhead ground wire to the phase conductors is typically 45 degrees. One overhead line (feeder 7) was built with transmissi

8、on type wood pole construction because the line extended to a research facility which was to have generated electrical power to feed back into the grid. Pole structure of this line are of durable wood cross a construction which utilize double ANSI 52-3 porcelain suspension insulators to support the

9、conductors (nominal 34 kV insulation). The shield angle of the overhead ground wire to the phase conductors for feeder 7 is typically 30 degrees. In 1969, an overhead line (feeder 8) was intentionally built with "lightning resistant" construction in an attempt to reduce lightning caused ou

10、tages. Pole structures of the line have phase over phase 24-inch long fiberglass suspension brackets with double ANSI 52-3 porcelain suspension insulators to support the conductors (nominal 69 kV insulation). The shield angle of the overhead ground wire to the phase conductors for feeder 8 is typica

11、lly 30 degrees. The failure data was compiled for each of the eight 13.8 kV feeders and is presented in Table, along with pertinent information regarding feeder construction, elevation, length, and age.A key finding of the failure analysis is that weather-related events account for over half (56%) o

12、f the feeder outages recorded. Fifty-seven of the 76 weather-related outages were attributed to lightning. Insulation breakdown damage due to lightning is also suspected in at least a dozen of the equipment failures observed. The data indicates overhead lines which pass over high terrain are less re

13、liable because of the greater exposure to lightning. For example, feeder 3 had the most recorded outages (48), of which two-thirds were due to weather-related events; this feeder is also the highest line on the plant site, rising to an elevation of 450 above the reference valley elevation. Overhead

14、lines that are longer and to which more substations and equipment are attached were also observed to be less reliable (more exposure to lightning and more equipment to fail). The age of the line does not appear to significantly lessen its reliability as long as adequate maintenance is performed; non

15、e of the lines have had a notable increase in the frequency of outages as the lines have aged. As would be expected, the empirical data presented in Table I confirms the two overhead lines which have been insulated to a higher level (34 or 69 KV) have significantly better reliability records than th

16、ose utilizing 15 kV class construction. Feeder 7 (insulated to 34 KV) and feeder 8 (insulated to 69 kV) have bad only 3 outages each over their 32 and 23 year life spans, respectively. These lines follow similar terrain and are comparable in length and age to the 15 kV class lines, yet they have a c

17、ombined failure rate of 0.22 failures per year versus 4.32 failures per year for the remaining feeders.On typical 15 kV insulated line construction, lightning flashovers often cause 60 cycle power follow and feeder trip. With the higher insulation construction, outage rates are reduced by limiting t

18、he number of flashovers and the resultant power follow which causes an over current device to trip. This allows lightning arresters to perform their duty of dissipating lightning energy to earth. The number of re closer actions and their resultant momentary outages are also reduced. This is benefici

19、al for critical facilities and processes which cannot tolerate even momentary outages. An additional benefit is that outages due to animal contact are also reduced because of the greater distance from phase conductor to ground on pole structures. Distribution line equipment to increase line insulati

20、on values are "off the shelf" items and proven technology. New lightning resistant construction typical by utilizes horizontal line posts, fiberglass standoff brackets or any other method which world increase the insulation value. The replacement of standard pin insulators with line post i

21、nsulators of greater flashover value is an effective means to retrofit existing wood cross arm construction. The doubling and tripling of dead end and suspension insulators is also a means of increasing flashover values on existing angle and dead-end structures. Current fiberglass, polymer, and epox

22、y technologies provide an affordable means to increase line insulation.While the use of increased insulation levels to reduce lightning flashovers and the resultant outages on overhead distribution lines has been thoroughly tested and demonstrated in laboratory and experimental tests 5, long term hi

23、story field data has positively demonstrated that the use of "lightning resistant" construction can greatly reduce outages. Field use at ORNL has shown that in areas which are vulnerable to lightning, the use of increased insulation and a smaller shielding angle is an impressive and cost e

24、ffective means to appreciably increase the reliability of overhead distribution lines. This reliability study clearly illustrates that the insulation requirements for high-reliability distribution feeders should be determined not by the 60 Hz operating voltage but rather by withstand requirements fo

25、r the lightning transients or other high voltage transients that are impressed upon the line. Electrical equipment (switchgear, insulators, transformers, cables, etc.) have a reserve (BE level or flashover value) to handle momentary over voltages, and by increasing that reserve, the service reliabil

26、ity is appreciably increased. As the electrical industry gradually moves away from standard wood cross arm construction and moves toward more fiberglass, polymer and epoxy construction, increased insulation methods can be applied as part of new construction or as part of an upgrade or replacement ef

27、fort. In considering new or upgraded overhead line construction, the incremental increased cost of the higher insulation equipment is d in proportion to the total costs of construction (labor, capital equipment, cables, electric poles, right-of-way acquisition), Its cost effectiveness varies with th

28、e application and the conditions to which it is be applied. Economic benefits include increased electrical service reliability and its inherent ability to keep manufacturing processes and critical loads in service. Other more direct benefits include less repair of overhead distribution lines, which

29、can have a significant reduction in maintenance cost due to less replacement materials and a large reduction in overtime hours for maintenance crews.*;抗雷擊架空配電線路的可靠性閃電仍然是架空配電線路上的中斷1的主要原因。通過實驗室測試和現場觀察和測量，雷擊和其對配電系統組件的屬性是很好理解的現象。本文提出了一個32年的歷史記錄，停運的原因，時間，地點，在橡樹嶺國家實驗室的八個配電饋線匯編。配電型避雷器在死胡同和角度的結構被放置在極安裝W奧莫爾的

30、位置，并在高點上的架空線。站級避雷器是用來保護地下電纜運行，墊置式開關柜，單位變電站變壓器。每個極接地的接地電阻通常是15歐姆或更小。在高海拔系統中，基本上是對地電阻大于15歐姆，尤其是在干燥的夏季。在這些高點，研磨棒極接地系統，在1960年，企圖以減少雷擊停電驅動和保稅。這些嘗試只是部分成功地降低停電率。從浪涌保護的角度來看，使用各種不同的桿件結構（列直插式，角，角，死路，等），和絕緣體及使用的硬件的各種不允許每13.8千伏架空線具有均勻的沖擊閃絡分類評價（170千伏，等）或一個數值的的BIL電壓類（95千伏BIL，等等）。在分析中為了簡單起見，每個分類的額定電壓建筑類（15千伏，34千伏，

31、69千伏）架空線。六七八個架空線（饋線1至6）建立典型的REA標準水平木橫擔，利用單級的ANSI 55-5瓷針式絕緣子（標稱15千伏絕緣）。架空地線相導線的屏蔽角通常是45度。一架空線（饋線7）建延長線傳輸型木桿建設，因?yàn)檫@是已產生的電能反饋到電網的研究設施。這條線極結構耐久的建設的其中利用雙ANSI 52-3瓷懸式絕緣子支持（標稱34千伏絕緣）。饋線7的架空地線的相導體的屏蔽角通常是30度。在1969年，架空線（饋線8）有意建立“抗雷擊”試圖減少雷電造成的停電。該行的極結構階段階段超過24英寸長的玻璃纖維懸掛支架與雙ANSI 52-3瓷懸式絕緣子，支持標稱69千伏絕緣的導體。饋線8架空地線的

32、相導體的屏蔽角通常是30度。編制各八個13.8千伏饋線故障數據列于表I中，沿饋線結構，海拔高度，長度，和年齡的相關信息。故障分析的一個重要發現是，與天氣有關的事件占了一半以上（56）的饋線停電記錄。五十七名76天氣有關的中斷是由于雷擊。絕緣擊穿損壞，由于雷擊還涉嫌至少有十幾觀察到的設備故障。數據表明架空線路經過地勢高，是不可靠的，因?yàn)槔讚麸L(fēng)險更大。例如，饋線3最錄制中斷（48），其中三分之二是由于與天氣有關的事件，這也是最高的饋線線廠區，上升到海拔450英尺以上的參考山谷高度。也觀察到架空線更長，更多的變電站和設備連接不可靠（多接觸雷擊和更多的設備失敗）。行的年齡似乎并不顯著減輕其只要足夠的維護;線中斷的頻率有一個顯著的增加作為線路歲。正如所預料的，實證的數據列于表我