杜邦耐鹽水腐蝕性測試資料

1、DUPONT TEFLON. FINISHES GLOBAL COOKWARE TEST METHOD PROTOCOLTITLE: SALT CORROSION TEST PROTOCOL耐鹽水腐蝕性測試GCTMP NUMBER : 02REVISION NUMBER : 2DATE OF REVISION : February 8, 2002DATE OF EXPIRING: February 8, 2005FILE: GCTMP02-SALT CORROSION C REV2.DOCWRITTEN BY : GLOBAL TEST TEAMMODIFIED BY : QPT TEAMAP

2、PROVED BY:SEGMENT PRODUCT LEADER: Martina M. WelcherREFERENCE: BRITISH STANDARD BS 7069 Appendix C. Corrosion- Modified(1) PURPOSE 目的To provide a method for testing the corrosion resistance of non-stick coating systems. 用來測試不粘涂料的耐鹽水腐蝕性。(2) PRINCIPLE 原理Exposure of coating systems to a boiling 10% NaC

3、L (salt) solution for a total of 24 hours. 噴涂一指定涂料體系的鍋子中，盛放 10%的氯化鈉(鹽水)溶液，煮沸 24 hrs。(3) APPARATUS 儀器3.1 Heat source 熱源3.2 10% NaCL solution 10 %的氯化鈉溶液3.3. De-ionized Water 去離子水(4) PREPARATION 準備4.1 Prepare test specimens in accordance to the procedure outlined on the product fact sheet for proper ap

4、plication, drying and baking of the specified Teflon. system.按 照產品 技術說明書的程序要求正確準備測試樣品，干燥并烘烤指定的特富龍涂料體系。4.2 Prepare 10% by weight, salt solution by combining 8 tablespoons (106 gr) Table Salt and 4 cups (960 gr) de-ionized water. 將 8 湯匙( 106 gr)食鹽溶解于 4 杯去離子水中 以得到重量百分比 10%的食鹽溶液。4.3 Prepare a mild dish

5、detergent solution with tap water. 用去離子水配備適度濃度的 洗滌劑溶液。(5) PROCEDURE 程序5.1. Wash the test specimens in dish detergent solution用. 洗滌劑清洗測試樣品。Rinse in cold water. 冷水淋洗測試樣品。Dry thoroughly. 完全干燥。Visually inspect coating surface for surface defects用. 肉眼檢查涂料表面缺陷。 Draw a diagram of the test specimen surface.

6、用 圓規畫出測試面積表面草圖。 Record all surface imperfections on the reference diagram. 在草圖上標出所有的表 面缺陷。5.2 Pour the 10% salt solution into the clean test specimen to a level past the midway point of the side wall of the vessel. 倒入 10%的食鹽水溶液于測試樣品中， 至少要達到 其內壁一半的高度Mark the water level on the side wall of the test s

7、pecimen. 在測試樣品內壁標注水 面高度Cover the test specimen with a lid. 蓋上蓋子。5.3. Place the test specimen on the heat source. Boil the solution for 24 hours.將 測試樣 品放在熱源上，加熱溶液 24hrs。Boil the solution for 24 hours. Add de-ionized water to maintain the water level within 15mm (6.6 inches) at all times.煮沸溶液 24hrs。每隔

8、一定時間(半小時左右) 添加去離子水，以保持水面高度偏差在 15mm(6.6 inches)以內。The 24 hour period may be continuous or, alternately, may comprise If the 8 hour interval is used, remove for the heat source safely. 2小4 時可以是連續， 也可以間斷 進行。比如可以選用 8 小時一個循環，總共三個循環。煮完后安全地從熱源上 移開樣品。Pour the remaining liquid from the test specimen at the e

9、nd of each cycle.在 最后的 循環后傾倒樣品中殘留的鹽水。5.4 Wash the test specimen in warm water using the mild dish detergent solution until adhering salt deposits are completely removed.使用溫和的洗滌劑在溫水中清洗樣品，直至殘留的鹽分完全洗掉。5.5 Visually examine the test specimens after each cycle for defects (blisters) not Present in the ini

10、tial mapping. Record new defects on the reference diagram. 每一循環結束后用肉眼檢查樣品表面新的缺陷(水泡) ，并在參考草圖上標注。5.6 Store the test specimens without liquid, dry, overnight. 放置無鹽水的樣品，干燥，過夜。5.7 Repeat the process until a complete 24 hours is completed. 重復程序，直到完成 24hrs 的測試時間。5.8 Visually examine test specimen for defec

11、ts and record on reference diagram. 用肉眼檢查樣品表面的缺陷并記錄在參考草圖上。(6) EVALUATION 評價6.1. Using the supplied Blister Rating Guide, compare the mapping diagram to the figures for the appropriate rating assessment. Record. 使用水泡評級指南來比較草圖上的缺陷，得出合適的評級數。(7) REPORTING 報告7.1. Report the blister rating including 報告水泡級

12、別。7.2 Record the following information about the test specimen: 記錄樣品的下列信息：Dry Film Thickness (DFT) 膜厚Substrate and surface preparation基 材以及基材制備Coating System 涂料體系 Manufacturer 廠商 Source 來源(8) PRECISION 精度The precision of the test has not been established. The test method and the rating system are su

13、bjective. Therefore it is recommended that for each set of experiments, the reproducibility is measured by including at least one reference (also calle“d standard” or control specimen) and data is gathered for each set separately精 . 度無法得到，測試方法 和評級體系是主觀的。因此，對于每組測試，建議使用參照品(稱之為標準樣或受 控樣品)來衡量測試的重現性，并且分開紀錄每