RestrictingAccesswhenIntrusionAreaisArmed

1、Application Note_The following document provides instructions on how to configure the Bosch Megapixel camera for motion recording with the Dibos Hybrid DVR. Both the MegaPixel camera(s) and Dibos require network connectivity to complete this procedure. The MegaPixel camera must reside within the sam

2、e subnet as Dibos.Megapixel Configuration1. Launch Bosch application manager for MegaPixel cameras.2. Run Camera Installer to set up cameras. The Bosch Camera Installer window opens. There are two modes of operation available: Basic and Advanced.3. In the Advanced Mode Select Find cameras; camera(s)

3、 should appear in the Present Cameras window. Result will be unchecked.4. Highlight the desired camera(s) in the list, then select Automatic:a. In Basic Mode, select Automatic;b. Result should indicate Success.5. Select Save/Exit.6. Run Video System to display live video:a. If multiple cameras have

4、been selected in step 5, drag and drop the desired camera into the live viewing window.7. Select the Archive link; under Archive/Filter select Save all and mark motion. 8. Select the Motion Detection link. The Motion settings window will appear and should display the State as Enabled.9. Configure th

5、e desired sensitivity, masking, and cell detection, then close the Motion Settings window:a. To set motion masking, left click and drag area to be masked in Motion Settings window. Masked area will appear highlighted in red.b. To remove masking, right click and drag area to be unmasked.10. Close Bos

6、ch application manager.Browser Interface1. Launch Internet Explorer.2. Enter IP address of MegaPixel camera in address window.3. Left click the Live video button.4. Right click on live video window and select properties.5. Left click and highlight information found in properties window for Address:

7、(URL).6. Right click on highlighted text and select copy 7. Close browser window.Dibos Configuration1. Launch Dibos application and log in.2. Select System, then Configuration.3. Under configuration, select Video and audio connections.4. Left click and highlight Network.5. Add Megapixel camera as a

8、JPEG IP camera under Network devices.6. Paste URL of MegaPixel camera in the Address window (see preceding browser view procedure).7. URL will include additional information at the end of the string: (i.e. - SSN and ID).8. Replace the SSN and ID with the following text: &mdn= 9. The portion is a var

9、iable and can be defined according to application needs (see highlighted example in the preceding image).10. Check Motion camera box and enter the port number defined in the previous step. Enter the text as shown in the On command and Off command fields shown in the following screen shot. 11. Select

10、 OK to save changes.12. Select Recording settings, then the IP camera tab.13. Highlight desired IP camera and define the Alarm recording rate. If required, copy these settings to other time periods, then select Save.14. Select Alarm Processing, then Add a job.15. Highlight the new job and define the trigger by checking the box next to the desired IP camera.16. Select Edit for