DSG(02E)基本設定.doc

DSG(02E)基本設定Prerequisites:ATF Temperature 30.100 C (86.210 F), see Measuring Blocks, Group 019. (ATF油溫達到30-100度，看測量數據塊19)Selector Lever in P (把換擋桿放到P檔)Ignition ON (點火開關打開)Engine ON (Idling) (啟動發動機怠速運轉)Brake Pedal operated (hold for the whole procedure) (踩下制動踏板，保持為整個過程)Throttle Pedal not operated (節氣門不要操作)NOTE: Be sure to perform the following steps in the sequence shown, followed by the defined test drive. (注意：必須順序向下做每一步，)Select02 - Transmission(進入變速箱)Basic Settings - 04(基本設定04)Transmission Tolerances (Engaged Calibration) (變速箱公差適應)Group 061(進入61區)Go!(執行)Activate the Basic Setting.(進行基本操作)ON/OFF/NextTransmission Tolerances (Synch. Point. Measurement) Group 060Go! (進入60區)Activate the Basic Setting. (進行基本操作)ON/OFF/NextClutch Adaptation (離合器自適應)Control Module Software Version = 0800 : (控制模塊版本高于0800)Group 067Go! (進入67區)Activate the Basic Setting. (進行基本操作)ON/OFF/NextReset Values (Clutch Safety Function) (重新設置數值，離合器安全功能)Group 068Go! (進入68區)Activate the Basic Setting. (進行基本操作)ON/OFF/NextReset Values (Pressure Adaptation) (重新設置數值，壓力適應)Group 065Go! (進入65區)Activate the Basic Setting. (進行基本操作)ON/OFF/NextReset Values (Steering Wheel Paddle Installation) (重新設置數值，轉向適應)Group 063Go! (進入63區)Activate the Basic Setting. (進行基本操作)ON/OFF/NextReset Values (ESP & Tip Cruise Control Installation) (重新設置數值，ESP和巡航適應)Group 069Go! (進入69區)Activate the Basic Setting. (進行基本操作)ON/OFF/NextDone, Go BackSwitch off Ignition, wait 10 Seconds and switch it back on. (關閉點火開關，等候10秒，再打開點火開關)Fault Codes - 02 (進入02讀故障碼)Check and clear fault codes after successful test.Close Controller, Go Back - 06Perform the Defined Test Drive