客房燈具規格書ga

1、Project Name項目名稱杭州酒店P(guān)roject No.項目2017009Ver版本No.08-Jun-17REF.NAME燈具名稱LOCATION應用位置Guest Room客房暗藏筒燈連玻璃片BRAND品牌Catalog NO.產品Dimen尺寸要求co(開孔)rd(筒深)w(闊)83mmmm 92mm diaLucent90413-F-XSM-700-30-245Or approved equal by Yamada, Shomei Erco, EndoAGENT商Creative Light Asia創新彩亞洲照明CONTACT（辦事處）CLAXSMLED,700lm,3000K

2、,warm white,Ra90,50,000hrs,11.4W,12V,250 LEDs must beLTYPEdby Luxeon, Cree, Xicato,Luds or Nichia,or equal by them光源參數XSMLED,700流明,3000K,暖白色,顯色指數不小于90,50,000小時,11.4瓦,700mA,25度,中角度LEDs 應由Luxeon, Cree, Xicato,Luds or Nichia生產或認可REMARKS燈具要求basub downlightProvide remote Provideer as requiredb louver as

3、requiredAluminum fitting body for easy heat outputfinish trim should be macth with the installation place or choose by the ID designerProvide clear glass at the hole suit for IP44the usage life should be more the LED decay rate must be lessn 30000 hours.n 80% in five years.all the parts could bed in

4、 five yearsrepairment should be finished in 8 hours after informed.洗手盆/浴缸筒燈提供整套LED電器.鋁制燈體以及良好的散熱功能提供蜂巢防眩光格柵.燈具完成面與安裝處相符或由室內設計師選擇.提供清玻璃片適用于防水條例IP44的地方光源的正常使用須在3萬小時以上五內的光衰率必須不小于80%其零配件五年內不得停產。故障，需保證接到用戶后8小時內緊急搶修完畢并恢復1/4TECHNICAL PARAMETERREF. CODEGA4技術參數燈具代號2/4TECHNICAL PARAMETERREF. CODEGA4技術參數燈具代號3/

5、4TECHNICAL PARAMETERREF. CODEGA4技術參數燈具代號LIGHT FIITTINGS CUT SHEET燈具規格說明1.All reflector cones shall be specular silver Alzak aluminium unless otherwise noted.所有反光罩應是ALZAK鋁片銀色全反光罩，除非另有注明。2.Voltage is amed 220v, 50hz, verify with electrical engineer. Provide transformers / control gear for light fittin

6、gs as required.Transformers shall be acsible through fitting ceiling cut-out unless otherwise noted.伏特以 220v, 50hz。 所有燈具應供應變壓器 / 鎮流器箱/LED電源箱等。 變壓器應可從燈具開孔處方便除出，除非另有注明。3.Or Equal does not imply automatic approval for alternate manufactureres listed. Submit alternate fittings for review / approval by L

7、ighting Designer. Refer to Light Fitting Specifications, General Conditions, for details.或相等不是暗示已批準所有取代產品商。依本燈光規范書，一般條文作參考，所有替代燈具應呈交給燈光設計師作及。4.Catalog numbers do not nesarily denote all required hardware and acsories. Provide all required acsories / hardwarefor complete installation of fittings as r

8、equired.產品不一定包括所有安裝配件。供應商應供應所有燈具安裝配件以便達到整套燈具安裝須求。5.Provide minimum 1 or 10% spare ls for each fitting type, whichever is higher.每種燈泡應供應最少 1 只或 10% 的額外燈泡 ( 以數量最高的那種作標準 )。6.Fitting trim rings shall be custom pa ed to match ceiling finis燈具的邊應特別涂油以配合吊頂天花的材料，除非另有注明。less otherwise noted.7.Control dimmer s

9、ystem shall be suitable for the full range dimming(100%-0% light output)in smooth square law dimming curveand check the dimming means with ther.若有調光要求,所提供的燈具應能滿足1-100%順暢輸出無頻閃的調光要求.8.All LEDS must bed by Luxeon,Cree,Luds or Nichia or approved by equal.所有的LED應由 Luxeon,Cree,Luds 或 Nichia 生產或認可的.9.Refer

10、 to Light Fitting Specifications,General Conditions,for light fitting requirements.燈具的要求及規范請認真查看燈具規格書.10. Light fitting shall be of contract quality and suitable for commerl use.燈具需符合項目要求及適用商業用途.11. Provide sle/prototype for review&approval as requested by the lighting designer or architect.所有的燈具需提供樣品給燈光設計師或建筑設計師審核12. Provide all acsories,including colour filters,louvers,etc.as describedhe light fitting schedule.按燈具規范中所描述的,提供照明設備所需的所有配件,包括顏色,反射罩,防眩光罩等13. Light fitting shall be approved and listed by UL,CSA,or other approved independent testing laboratory